G46-6201

[LgMouthGambler]

What are the dimensions for this bearing?

[LgMouthGambler]

Its the level wind bearing for the Zillions

[LgMouthGambler]

Man, still no help? I really don't want to tear this thing down just to find out that the bearing that I hopefully can use is not going to work.

[toddmc]

I would call the the Tackle Trap.

[hoohoorjoo]

Don't know the dimensions, but it is the same bearing that is under the knobs. I know because I used 2 handle bearings for the levelwind in my Tatula.

[LgMouthGambler]

Do you happen to have a part #?

[hoohoorjoo]

Do you happen to have a part #?

F28-3101 is the part number. I found it in the diagram for the TDA153HSTA. But Daiwa wants ~$8 each for those little buggers, plus the exhorbitant shipping and handling costs(minimum of $8). If it was me, I would just pick up a 4-pack here:
http://tackletrap.com/index.php?main_pa ... ts_id=3319
Then you will have 2 extra bearings that you can use to replace one bushing under each knob and smooth the reel out even further.

[LgMouthGambler]

Do you happen to have a part #?

F28-3101 is the part number. I found it in the diagram for the TDA153HSTA. But Daiwa wants ~$8 each for those little buggers, plus the exhorbitant shipping and handling costs(minimum of $8). If it was me, I would just pick up a 4-pack here:
http://tackletrap.com/index.php?main_pa ... ts_id=3319
Then you will have 2 extra bearings that you can use to replace one bushing under each knob and smooth the reel out even further.

Thanks. I actually pulled the Coastal apart and took the bushing out. For some strange reason I happened to have 1 bearing in my little bag of parts that was the same dimension. So in the worm gear it went. When I went to my friend Mikes (owner of Hawg Tech), I asked him if he had any of those laying around. He did not, but I really only needed the one. I changed out the whole handle with a curved Hawg Handle with blue accents anyway, so now its super smooth! Thanks again for the help.

[Daiwa]

G46-6201 has a dimension of 5x8x2.5. I do apologize for the late response.