Boca Bearings Support

[tyrtok]

i would like to raise up an issue. normally i gauge the bearing due to their 'spin time' on a piece of wooden rod without any load, i noticed something weird. on my new boca orange seal, the 'spin time' on 1 side of the bearing is 20 seconds, the other side would be like 5 seconds. it happens to both my bearing i ordered for my curado. is this normal? i suspect the bearing or cage is spinning against the seal.
regards,
tyrtok

[Str8upirish]

I'm looking for some bearing for my Quantum EX501 do you guys make bearing for them?

[Nitroman77]

my guess would be a 3x10x4, 5x11x4, but they dont have it on their site yet and I havent had one in the shop yet..
There could also be a 3x8x4 bearing in there as well..

[Pegasus]

Hi Larry
I recently purchased a set of Orange Seals for my Chronarch 101 D7
After taking the seals off I noticed that they look a little different than a set I purchased a year ago.
The little ceramic balls of the previous set are much darker in color. The ones I recently got look silver.Have you guys changed something ? because they are much louder than my previous set and don't seem to run as smooth. The only difference I did is that I didn't flush this set before installing them, but i am still running the same Oust oil from Smooth Drag.
Please advice

Regards
Pegasus

[VEEDUBGYRL]

great customer service thus far! i just ordered my bearings...

[Nitroman77]

Ive been working along side Boca for a couple years and they are great PEOPLE!