poisonokie wrote:DirtyD64 wrote:
I use it on an old Zillion TWS with a 7'3"MH and the issues mainly occur with 1/2 FB jigs or slightly heavier lures. Senko's, lighter TX rigs, lighter 4" or less swimbaits, etc. don't really do it so bad. Just seems I would rather have fluoro now and I'm tempted to switch to 12lb mono on my topwater setup rather than the same mentioned 30lb braid.
First off, I'm sure you know all this, but I thought I'd lay it out there anyway.
It might help if you either flush your bearings or slap some hedgehogs in there. On reels with braid is where I see the greatest benefit from ceramics. I bet you're casting a lot harder and farther with that football jig, which increases the likelihood of a backlash from the increased spool RPM. Ceramics would smooth it out and help it maintain a constant speed.
Also 30# is pretty thin, which causes the digging. Going to 40 would help without impacting distance too much. It'd be great if they made a faster worm shaft for use with braid on the Zillion TWS, but afaik they don't.
As far as the line for topwater goes, you can go heavier. If you spool up all the way with 16#, you'll have plenty of line for bombing casts, plus it will help keep your lure on the surface since it floats better because it doesn't break the surface tension as easily. Also you have the added benefit of a more secure link to your pricey plugs. I use 16# super natural on a basically stock OG Tatula for a lot of topwaters and get hella distance and great action out of my lures.
Thanks, I will have to give this a shot. Not really sure which mono is best, I have never really used it except for Carolina rig leaders (thought it was supposed to help lure float, it didn't). I throw pretty small topwaters the few times I do throw them, do you think 16lb mono will still allow me to chunk little poppers and walkers without affecting their action negatively?