Page 1 of 1

Metanium DC - maintenance

Posted: Sun Feb 04, 2018 10:45 am
by Ovidiu-Andrei
Hello,

What basic maintenance do I have to do on a 15 Metanium DC?
Do I have to lube with oil the bearing of the spool on e period of time? Other bearings?

Tks

Re: Metanium DC - maintenance

Posted: Mon Feb 05, 2018 5:33 am
by Ovidiu-Andrei
So,

Can anyone help with an advice?
How and what bearings can I lube in basics?

Tks

Re: Metanium DC - maintenance

Posted: Mon Feb 05, 2018 9:30 am
by Cracker
Do the spool bearings only, soak them in acetone and lube (one drop) with oil you like.
Maintenance in general, all depends, I usually do my reels once in two years completely taking them apart.

Re: Metanium DC - maintenance

Posted: Mon Feb 05, 2018 10:58 am
by PikeRoadBassn
The 4 biggest things you can do to extend the life of your reels is

1) try to keep it as clean as possible. wipe it down, keep it out of the elements when not in use.

2) keep the level wind lubed. I prefer grease for this, as it helps catch any debris and floats it up in the grease instead of allowing it to settle into the worm gear like oil does

3)flush and oil the bearings. preferably 2 time a year, but once will be fine on flushing them. oil them every few trips. just one drop is more than enough to last a few trips.

4)grease the gears. the gears in the metanium can and will become loud and "geary feeling" if they run dry. once is all it takes to ruin them.

Re: Metanium DC - maintenance

Posted: Wed Feb 07, 2018 2:55 am
by Ovidiu-Andrei
Met DC doesnt have a bearing at levewind...
Do you know if it is necessary to ad bearing(s) at the levewind? Or the question is if it has place there to ad one?

Tks

Re: Metanium DC - maintenance

Posted: Wed Feb 07, 2018 11:56 am
by lifeofRiley
don't worry about adding any additional bearings. The factory knows what it's doing.

Re: Metanium DC - maintenance

Posted: Thu Feb 08, 2018 5:34 am
by PikeRoadBassn
lifeofRiley wrote:don't worry about adding any additional bearings. The factory knows what it's doing.

They don't add them to keep the price point down. A bearing is better than a bushing in EVERY instance EXCEPT saltwater use.

Re: Metanium DC - maintenance

Posted: Thu Feb 08, 2018 8:19 am
by Ovidiu-Andrei
So,

At the levelwind...do.you think that I could add 1 bearing or 2? Is there anu place?

Tks

Re: Metanium DC - maintenance

Posted: Thu Feb 08, 2018 9:28 am
by Mike son
Ovidiu-Andrei wrote:So,

At the levelwind...do.you think that I could add 1 bearing or 2? Is there anu place?

Tks
Just look at the schematic... there is no bearing on the levelwind nor is there a bushing to replace. So no, you cannot add a bearing or two to the levelwind.

http://www.plat.co.jp/parts/SHIMANO-BAI ... -03378.pdf

Re: Metanium DC - maintenance

Posted: Thu Feb 08, 2018 9:55 am
by Ovidiu-Andrei
Ok. Tks.
Probably doesnt need if Shimano didnt made possible that.