SHIMANO tranx 400 handle bearing size
SHIMANO tranx 400 handle bearing size
I was hoping to replace the plastic “bearing” in the tranx power handle and wanted to confirm what the size was. Thanks!
Re: SHIMANO tranx 400 handle bearing size
If you are using the reel in saltwater I would leave the bushing in place. I will have to measure the bushing to determine the size and if we have a bearing available. I do not have the specs on hand.
Re: SHIMANO tranx 400 handle bearing size
Hi bantam,
Thank you for looking into this for me. I will wait to see what size specs you can find.
Thank you for looking into this for me. I will wait to see what size specs you can find.
Re: SHIMANO tranx 400 handle bearing size
I had to order a handle to disassemble. I will have an answer for you tomorrow or Friday.
Re: SHIMANO tranx 400 handle bearing size
wow thanks for looking into this. it is very much appreciated.
Re: SHIMANO tranx 400 handle bearing size
Here you go:
Inner bushing in OD x ID x W
9 x 5 x 3 mm
Outer bushing in OD x ID x W
9 x 4 x 4 mm (actual width measured 3.78mm so it might be hard to use a bearing in this location due to the width)
Inner bushing in OD x ID x W
9 x 5 x 3 mm
Outer bushing in OD x ID x W
9 x 4 x 4 mm (actual width measured 3.78mm so it might be hard to use a bearing in this location due to the width)
Re: SHIMANO tranx 400 handle bearing size
thank you bantam for the info!
Re: SHIMANO tranx 400 handle bearing size
Is it ok to put a 400a handle on a 400hg?
Re: SHIMANO tranx 400 handle bearing size
Yes the handles are interchangeable.
Re: SHIMANO tranx 400 handle bearing size
Yep not a problem swapping the handles out.