TackleTour

I am helping a friend to buy shimano stock spool bearing for 01 calcutta conquest 50.

For this reel and othet small reels, shimano uses a small bearing 3x7x3 at the tension knob side.

Check the schematic from shimanon US site but cannot find a part# just for this bearing, but a whole spool assembly including the bearing.


Can someone show a part# for 3x7x3 bearing only so we can order directly from shimano?

Thanks

Ben

Did you look at Boca?

Tommy,

Thanks for reply my 1st post.

Yeah, I believe boca or hedgehog has the size we need but prefer the stock beering. If we can't source it from shimano then we have to go to these brands

I need to know OD x ID x W to check my bearing chart. I know some of the bearings we never received a part number or replacement bearings for due to low demand.

Bantam1 wrote:I need to know OD x ID x W to check my bearing chart. I know some of the bearings we never received a part number or replacement bearings for due to low demand.

Hi Bantam,

the dimension is on the title, 3 (ID) x7 (OD) x3 (W) mm, thank you!

I checked my bearing size list and can't find any bearing that matches the dimensions you listed. This is one of the bearings we never received a part number for and required the spool to be replaced if it needed a bearing. In this case you will have to use an aftermarket bearing unfortunately. The closest bearing we have in size is 7 x 4 x 2.5 (OD x ID x W).

We have bearings for the CTE50GT.

Bantam1 wrote:I checked my bearing size list and can't find any bearing that matches the dimensions you listed. This is one of the bearings we never received a part number for and required the spool to be replaced if it needed a bearing. In this case you will have to use an aftermarket bearing unfortunately. The closest bearing we have in size is 7 x 4 x 2.5 (OD x ID x W).

We have bearings for the CTE50GT.

Bantam,

could you help to double check if BNT2810 is the same size I am looking for? it's from CTE50GT I believe.

thanks

Ben

The part number BNT2810 is the 3x7x3 spool bearing from under the cast control cap of the CTE50GT.

https://www.ebay.com/itm/Shimano-Ball-B ... 2930661648

That bearing is discontinued.

Zimbass wrote:The part number BNT2810 is the 3x7x3 spool bearing from under the cast control cap of the CTE50GT.

https://www.ebay.com/itm/Shimano-Ball-B ... 2930661648

Thanks

Bantam1 wrote:That bearing is discontinued.

Oops... too bad.. seems we have to get after market bearings.

Thank you Bantam