Curado K Levelwind Bearing
-
- Elite Angler
- Posts: 328
- Joined: Tue Aug 26, 2014 4:30 am
- Location: PA
Curado K Levelwind Bearing
Does anyone know what size bearing I need for the levelwind on a Curado K? Or better yet, is it the same size bearing that the Ch/Met MGL uses?
Thanks.
Thanks.
- rockchalk06
- Elite Angler
- Posts: 530
- Joined: Fri May 24, 2013 5:49 pm
- Location: OK
Re: Curado K Levelwind Bearing
Yes sir. It's also the same size bearing that's in your knobs. 4x7x2.5
-
- Elite Angler
- Posts: 328
- Joined: Tue Aug 26, 2014 4:30 am
- Location: PA
Re: Curado K Levelwind Bearing
That's what I was expecting but I wanted to make sure. I'm guessing you've already done a few of these Rock.
I haven't taken the knobs off any of my K's yet. Is the factory configuration 1 bearing and 1 bushing on the knobs?
I haven't taken the knobs off any of my K's yet. Is the factory configuration 1 bearing and 1 bushing on the knobs?
- rockchalk06
- Elite Angler
- Posts: 530
- Joined: Fri May 24, 2013 5:49 pm
- Location: OK
Re: Curado K Levelwind Bearing
Yes sir. I've done quite a few here locally. The 200k is a pretty big hit around here where the lower end tier of reels shines. Most are using them for Cats of all things lolfishballer06 wrote:That's what I was expecting but I wanted to make sure. I'm guessing you've already done a few of these Rock.
I haven't taken the knobs off any of my K's yet. Is the factory configuration 1 bearing and 1 bushing on the knobs?
On the 200K, it's two bushings per knob unfortunately. You'll need 5 total to replace all the bushings.
-
- Elite Angler
- Posts: 328
- Joined: Tue Aug 26, 2014 4:30 am
- Location: PA
Re: Curado K Levelwind Bearing
Woof...rockchalk06 wrote:On the 200K, it's two bushings per knob unfortunately. You'll need 5 total to replace all the bushings.fishballer06 wrote:That's what I was expecting but I wanted to make sure. I'm guessing you've already done a few of these Rock.
I haven't taken the knobs off any of my K's yet. Is the factory configuration 1 bearing and 1 bushing on the knobs?
I'm looking to do 3 Curado K's and a ChMGL. Now to find the best deal around on 18 of these bearings.
-
- Platinum Angler
- Posts: 1103
- Joined: Mon May 28, 2012 3:59 pm
- Location: WI
Re: Curado K Levelwind Bearing
Fishballer06, check your PM.
Re: Curado K Levelwind Bearing
Installing the bearing on the worm shaft will not gain you much difference in feeling. Trust me I have tried it. But to each his own...