Curado 200 D anti reverse bearing removal?

[JBA]

I was trying to remove the anti reverse bearing from the side plate I could not get it to budge at all. Is there an easy way to remove this and which side of the side plate does it slide out?

[Bantam1]

The bearing should slide out towards the handle side. The factory has been addind a small amount if adhesive to hole the bearing in place. You can use a 10 mm nut driver and a hammer to lightly tap the bearing out of the side plate.

[JBA]

Bantam1 what is the best way to lubricate the Anti reverse bearing on shimano baitcasters?

[Bantam1]

Very little lubrication is needed. The bearing can slip if you use too much oil. The best way is to put some of our oil on a Q-tip and lightly swab the surface of the rollers or inner tube.