I do not have the schematic for these yet. The reels should have the schematics in the box. I just do not have a pdf version to check yet.

Sorry for the delay in this response. We have been waiting for Japan to confirm the part numbers. It appears there was a mistake made and the 100HY is the correct part number for the gear. They have been ordered for our inventory and hopefully will come on the next parts shipment at the end of June,...

BNT4044 does show TGT2882 as a sub. We have 71 in stock currently.

I need to talk to our parts guy. There is a note stating Japan redesigned and use the new number, but the new number is not showing on my side. The 100HY is discontinued due to the change. I think he is back from vacation today. If not I will email Japan and hopefully have an answer by tomorrow morn...

The drive gear is forged and they run very tight tolerances. Any alteration will damage or ruin the gears even further. Essentially I would just consider them not useable and toss them or recycle the materials.

Yes you have to turn the reel upside down to install the A/R bearing. This way it will not come apart. That could be the cause of the noise as well.

The reels are pretty well sealed so rain should not be an issue.

There was a change to the part number a while back. The new global part number is 10LZD. We are currently backordered until 8/25, but I think we can match it up if you stop by.

The bearing is pressed into the side plate and not east to get out. Usually it requires a delicate beating with a modified flat blade screw driver and a hammer, or the use of a good blind bearing puller. Usually they will only cause noise if there was corrosion in the bearing. It is very rare for th...

Have you determined which screw you are missing? We might be able to match something up if they are no longer in stock. We do not sell part over the counter, but you can order online through our website or by calling 877-577-0600.

I do not have an exact torque spec, but it probably doesn't need to be more than 15 inch pounds based on the side of the screws. The gear will stay in place but you have to push down against it while removing the side cover. I use the back of one of my precision screwdrivers to keep it there. Things...

There should be one end with a groove for the c or e clip and the other end has a "T" for the idle gear to attach. A spacer can be added under the idle gear to help space the wormshaft if it needs adjustment. The Chronarch D should have had one spacer, maybe 2 at most. If the line is stacking toward...

Where did you grind/cut the wormshaft? It should have been a direct swap. It's possible the replacement you received was not marked correctly and for a different reel.

The closest rods we have for power and action will be Zodias ZDC70MLGA, Curado CDC70MLGA or a touch more power G.Loomis IMX-PRO 903C CBR. The IMX is the only 7'6" model that is close. The 841C is 7' but a true ML cranking rod.

10F5C is the part number for the AR bearing. We have them in stock.

Try Southwestern Parts & Service in Dallas, TX or Coastline in North Carolina. BNT3822 can be used, the material and coating is slightly different but it will fit and work.